Open Daily: 10am - 10pm | Alley door pickup 10am - 7pm 3038 Hennepin Ave Minneapolis, MN
612-822-4611

  • Open Daily: 10am - 10pm
    Alley-side Pickup: 10am - 7pm

    3038 Hennepin Ave Minneapolis, MN
    612-822-4611

Open Daily: 10am - 10pm | Alley-side Pickup: 10am - 7pm
3038 Hennepin Ave Minneapolis, MN
612-822-4611
Numerical simulation of the behaviour of thin parts during milling

Numerical simulation of the behaviour of thin parts during milling

Klein Fiorentin, Felipe

Paperback

Technology & Engineering

ISBN10: 6207689755
ISBN13: 9786207689750
Publisher: Our Knowledge Publishing
Published: Jun 22 2024
Pages: 60
Weight: 0.22
Height: 0.14 Width: 6.00 Depth: 9.00
Language: English
In marine engineering, thin parts such as propeller blades and heat exchanger fins are commonly used. These parts often undergo a machining process. Because these components are relatively flexible, machining them is a delicate process. The removal of material is inherent in any machining process, so variations in the mass of the part exist. In addition, as the geometry of the parts changes, variations in rigidity also occur. These two parameters determine the natural frequency of an object and, together with the damping factor, also determine the resonance frequency. Another factor that influences the rigidity of the assembly is the fastening system. You should avoid exciting these components at frequencies close to resonance. In order to minimize the vibrations of the workpiece during the machining process and consequently improve the surface finish, this study aims to use numerical simulation using the finite element method to predict the dynamic behavior of a given system by analyzing its vibrations. By correlating vibration amplitudes with roughness, it was possible to estimate the surface finish.

Also from

Klein Fiorentin, Felipe

View All

Also in

Technology & Engineering

View All